hotel application, hand dryer, hand blowing machine with stainless material

Product introduction           

Usage method：           

Note: before leaving the factory, we need to take account of different installation environment. Therefore, the infrared launcher should be adjusted to the middle stage. If it is installed for a long time or does not work, it can adjust the fine adjustment resistor.           

1. hand dryer installed on the power at work state.           

2. when the hand is in the 5cm range of the dry hand outlet, the dry hand works automatically and sends out the hot air. When the hand is left one second, the work is stopped automatically. When the dry hand works for 1 minutes, it will automatically stop working and re - induction will continue to work.           

Installation method:           

Note: before connecting the power supply, a two level switch must be installed, and the switch contact distance is more than 3mm. This machine must be connected to the ground wire.            1. in installation position on a set of mounting screw holes, and drill of 8mm, 35mm deep hole;            2. disassemble the shell in order and take care not to overforce the outer shell to prevent the connection between the shell and the outer shell.           

3. with the rubber plug and screw attached randomly, the ground base is fixed on the installation position.           

4. first, the ground wire joint is connected with the shell connection, and then the induction head of the shell is connected.           

5. then the shell is hung on the base of the base, and the bottom end of the shell is pressed to the base, and it is used by the randomly attached six angle plate.